Our Seat Belt Tag Not all belts in the marketplace meet acceptable standards. Every seat belt or safety restraint we offer has been thoroughly tested to meet or exceed SAE & FMVSS regulations. A certification tag sewn into the belt fabric may be required for DMV and OSHA inspections. All of our seat belts have a tag sewn in clearly stating the testing certification.

We start by removing the seat, interior upholstery, and anything else that may be in the way for the installation. You may not need to do this, but it does make it easier.

Next feed a piece of string down the pillar through the hole that is located about halfway up the quarter window.

These are the custom designed mounts that will be installed in the pillar to mount the shoulder point.

Feed the lower end of the string through the hole at the top of the mount and tie a knot to form a loop.

Pull the string up through the hole until the threaded hole in the mount is aligned with the hole in the pillar and install the shoulder bolt to hold it in place.

Drill through the pillar and into the mount so you can install 2 small screws to hold the mount in place.

Now bolt the shoulder point in place so you can lay out the floor mounting point.

Since this car already had lap belts in it, we used those mounting points on the floor to attach the retractor mechanism.

Next put the opposite end of the belt on the bolt and tighten in place.

Now install the inboard soft arms. If your car didn't have belts in it, you will need to put the seat back in to lay these out. Always be sure to check below the car to be sure there are no obstructions under the floor pan.