Seat Belt Tag
Drill through the pillar and into the
mount so you can install 2 small screws to hold the mount in
Since this car already had lap belts in it, we used
those mounting points on the floor to attach the retractor
Next put the opposite end of the belt on the bolt
and tighten in place.
Remove the top mount and layout upholstery to modify it for
the top mount. Re-assemble with the upholstery in place and
install plastic covers.
Now install the inboard soft arms. If
your car didn't have belts in it, you will need to put the seat
back in to lay these out. Always be sure to check below the car
to be sure there are no obstructions under the floor pan.